Juniper CTP Series - Page 107

Current port mirror configuration: None
Options(0-quit, 1-add, 2-delete, 3-show): (0-3)[3]: 1
5. Enter 1 to configure port mirroring.
6. Follow the onscreen instructions and configure the parameters as described in
Table 46 on page 101.
Table 46: CTP Bundle Source Port Mirroring Settings in CTP Menu
Your ActionField
Select one:
•
yes
•
no
Add Source mirroring
Enter the remote IP address.Enter remote ip address
Enter the remote circuit ID in the range 0-249.Enter remote cid
Select one:
•
yes
•
no
Add Destination mirroring
Enter the remote IP address for the destination port.Enter remote ip address
Enter the remote circuit ID in the range 0-249.Enter remote cid
7. From the Operations Menu, select 4) Activate to activate the bundle.
Related
Documentation
Configuring Port Mirroring for CTP Bundles (CTPView) on page 99•
101Copyright © 2018, Juniper Networks, Inc.
Chapter 2: Configuring CTP Bundles