JVC CL-S500 Series

- 22 -
Setting method 2
You can assign the AUTO TEXT MODE function to the function buttons (F1 or F2) which
allows you to enable or disable the function easily via button operation. The following
explains how to assign to the “F2” button.
1) Display the “Operation Button Guide
①
” by pressing any one of operation buttons
(A–C)
.
2) Press the “MENU” button.
3) Select “FUNCTION” from MENU 1/2 using the “▼” or “▲” button and press the “OK”
button. Then select “FUNCTION2” from “FUNCTION” OSD and press the “OK”
button.
4) Select “AUTO TEXT MODE” from “FUNCTION2” OSD and press the “OK” button.
5) Display the “Operation Button Guide
①
”by pressing any one of operation buttons (A–
C)
.
6) Switch “AUTO TEXT MODE” by pressing the “F2” button.
You can enable or disable the “AUTO TEXT MODE” function by pressing the “F2”
button.
You can also check whether the function is enabled or disabled from the “AUTO-
TEXT” status on “INFORMATION 1/2” OSD.
INFORMAT ION 1/2
MODEL : CL-S500
SERIAL : ** * * * * * * * * * *
VSPU : Re v.A
MPU : Re v.A
ACT T IME : 9 9 9 9 9 H
LAST CAL : 9 9 9 9 9 H
ED ID : La n d s c a pe
D-GAMMA : D i s a bl
e
AUTO - TE XT : E n a bl
e
H-SE N S O R : D i s a bl
e
5MP
INFORMATION 1/2
Auto Text Mode