CONFIRM POWER-OFF STATUS
M_l<esureall tile units_re turned off,
ATTACH CAMCORDER TO AC
CHARGER STATION
Attach tile camcorder to tile A( Charger
Station referring to step 2 as shown ill tile
illustration on pg. 5}.
CONNECT CAMCORDERTO PRINTER
OR VIDEO UNIT EQUIPPED WITH
DV INPUT CONNECTOR
Pull out the connector cover and open it. Make
connections to th@ device you want to conn@ct
to LIsJngthe DV cable, as shown ill the
illustration.
CONNECT PRINTER TO PC
Connect the printer cable to the printer's
PARALLEL connector and tile P('s PARALLEL
(PRINTER) connector.
_ UPPLY POWER
Plug tile AC ( harger Station's power cord into
an A( outlet.
TURN ON POWER
Turn tile Call/corder's Power Dial to "PLAY",
"l_!" or "_" while pressing down the loci<
button located on the dial and turn on the
other units.
NOTES:
• You cannot use the battery pack installed in the
_mcorder as the power supply since a digital
signal b output from the DV OUT connector
only when using the AC Charger Station.
• Whorl using tile can'lcordfr lbr dubbing, be stlr_
to use it as a I_lay_;: Tile camcorder's DV
corlrlector is only f_r output,
@Also rdfdr to the instnlction manuals of the
connected units.
To Next Page
Loading...
