+
Note: if ARQBBS is ON, you will not be able to transmit FEC from the Standby
modes.
See also: arqid, pbbs.
ARQID
n (n=0-31)
default 9
This command sets the time interval in 1 minute increments for an automatic CW
ID when operating AMTOR, G-TOR, or Pactor ARQ. The CW ID will be trans
-
mitted at the speed set by the CWSPEED command, and the text of the ID is set
with the CWIDTEXT command. Setting ARQID to 0 disables the automatic ID.
See also: arqbbs, cwid.
ARQTIME n (n=1-10)
default 2
This command sets the timeout interval when attempting to link to another sta-
tion in AMTOR ARQ mode. The interval is set in increments of 64 ARQ cycles
(approximately 28.8 seconds).
See also: amtor.
ASCBAUD n (n = 20 - 500)
default 110
This command sets the default baud rate used when entering the ASCII mode
with no baud rate specified.
See also: ascii.
KAM’98 Commands Command Reference
KAM’98 v 8.3 229 User’s Guide
To Next Page