ASCII [n] (n = 20 - 1200)
immediate
This command places the KAM’98 in ASCII mode. If you specify the optional
value n, the KAM’98 will enter ASCII at the specified speed; otherwise it will
operate at the speed set in ASCBAUD.
Note: When switching from 300 baud packet operation on HF to 1200 baud packet
operation on VHF/UHF, remember to change the following (HF defaulted) parame
-
ters: Mark, Space, SWP, Slottime, Persist, Maxframe, Paclen, Hbaud. See the
packet section in the modes of operation chapter for further detail (page 144).
See also: ascbaud, autostrt, canline, hbaud, pmode.
AUTOCR n (n=0-255)
default 0
A carriage return <CR> character is sent to the radio after n characters are typed
on a line when operating RTTY, ASCII, AMTOR, G-TOR, or Pactor. Setting
AUTOCR to 0 disables automatic carriage returns.
AUTOLF {ON | OFF}
default ON
When ON, a line feed is sent to the terminal after each carriage return. This pa
-
rameter should be set on when overprinting occurs and the terminal being used
does not automatically supply its own linefeed after a carriage return. This com
-
mand affects only the data sent to the terminal, not data sent to the radio.
See also: cr, lfadd
Command Reference KAM’98 Commands
User’s Guide 230 KAM’98 v 8.3
To Next Page