will continue to be displayed until you type the next character of your current
message.
You can use the REDISPLAY-packet character to see a “clean” copy of your in
-
put if you are using a printing terminal (or have BKONDEL OFF) and you have
deleted characters. The REDISPLAYed packet will show the corrected text.
You can also use this character if you are typing a message in Convers Mode and
a packet comes in. You can see the incoming message before you send your
packet, without canceling your input.
See also: bkondel, canline, canpac, flow
RELINK {ON | OFF}
default OFF
When OFF, the TNC operating with AX25L2V2 ON does not attempt to auto-
matically reconnect. When ON, the TNC operating with AX25L2V2 ON will at-
tempt to automatically reconnect after RETRY is exceeded.
The KA-Node and the PBBS will never attempt to reconnect regardless of the
setting of this command. If using AX.25 Level 2 Version 1 (AX25L2V2 OFF)
this command has no effect.
See also: ax25l2v2, retry, tries
REPHASE {ON | OFF}
default ON
When ON and operating Mode A AMTOR, the KAM’98 will automatically at
-
tempt to rephase with the other station if repeated errors occur. When OFF, re
-
peated errors will cause the KAM’98 to return to AMTOR Standby mode.
#
RESET
immediate
Command Reference KAM’98 Commands
User’s Guide 302 KAM’98 v 8.3
To Next Page