This command is used to perform a soft reset. Contents of the mailbox (PBBS)
are kept, and the NDHEARD and MHEARD logs are not cleared. Any existing
connections which are not conpermed will be lost, even though the other station
still indicates a connection to your station. The initial sign-on message will be
displayed.
See also: intface, maxusers, myremote, numnodes, pbbs, restore
RESTORE DEFAULT
immediate
When RESTORE D is given, the KAM’98 will revert to it’s factory default set-
tings, perform it’s AUTOBAUD routine, and erase PBBS memory (deleting all
messages and non-default PBBS parameter settings).
See also: reset
RETRY n (n=0-15)
default 10
This command specifies the number of packet retries. Packets are re-transmitted
n times before an operation is aborted. The time between retries (when no ac
-
knowledgment is received) is specified by the command FRACK.
See also: ax25l2v2, frack, relink, tries
RING {ON | OFF}
default ON
When ON, three bell characters ($07) are sent to the terminal with each “***
CONNECTED TO” message (when another station initiates the connect).
KAM’98 Commands Command Reference
KAM’98 v 8.3 303 User’s Guide
To Next Page