RNRTIME n (n=0-255)
default 0
RNRTIME is set in 10 second increments. If a connection stays in a remote de
-
vice busy state (continues to receive RNR frames) for RNRTIME, the TNC will
disconnect. If a KA-Node connection stays in a remote device busy state for
RNRTIME the KA-Node will disconnect the input and output sides of the
KA-Node circuit. Setting RNRTIME to 0 disables this function.
See also: mresp
RPRINT text (text up to about 250 characters)
immediate
This is an immediate command which sends the “text” string to the device
attached to the RS232 port (e.g. a GPS unit). It is intended to allow a remote
SYSOP (connected to the KAM’98 with the MYREMOTE callsign) to send a
string to a unit attached to the KAM’98 serial port. The string content could be
used to change the configuration of a GPS unit.
RTEXT text (text up to about 250 characters)
default (blank)
This command sets the password string for use when accessing the MYREMOTE
or when performing SYSOP functions in the PBBS remotely. When you connect
to the MYREMOTE or attempt to enter the SYSOP mode of the PBBS, the TNC
will send three sets of numbers, one of which must be properly decoded (match
-
ing position number with string character) using this string.
For instance, if the RTEXT is set to “Test” and you connect to the MYREMOTE,
the TNC would send three sets of random numbers. The numbers would look
like:
Command Reference KAM’98 Commands
User’s Guide 304 KAM’98 v 8.3
To Next Page