1234
1324
4311
You must then pick ONE of these lines and decode the password string (i.e., as
-
sign letters to each letter position). Let’s say you choose to decode line 3
(4 3 1 1). Rewriting the RTEXT string to make this easier we have:
(position) 1234
(#) 4311
(letter) t s t t
Now, decoding the string, character 4 is “t” character 3 is “s”, character 1 is “ t”
and character 1 is “t”.
You must send the following in response to the string of numbers:
tstt
If correct, you’ll receive the MYREMOTE prompt (“prompt:”).
+ Case is significant and spaces are valid characters.
If you fail to properly decode the password, the remote KAM’98 will send three
new lines of numbers. You will be given a maximum of three attempts to prop-
erly decode the password string. If you fail in three attempts, the TNC will dis-
connect. After failing in three attempts, the MYREMOTE is disabled for 15
minutes.
RTTY n (n = 20 - 1200)
immediate
This command places the KAM’98 in the RTTY mode. The parameter n sets the
transceiver baud rate. If n is not specified, the baud rate specified in RBAUD is
used.
See also: autostrt, canline, pmode, rbaud.
KAM’98 Commands Command Reference
KAM’98 v 8.3 305 User’s Guide
To Next Page