Because the comma is missing, the command is interpreted as if it were
BUDLIST QST,KBØNYK; the NØKN is ignored.
INVALID STREAM
The stream you have tried to change to is not valid. Stream designators must
be letters A - Z. MAXUSERS sets the upper limit on valid streams.
KANTRONICS ALL MODE COMMUNICATOR KAM’98 VERSION 8.3
(C) COPYRIGHT 1991-1998 BY KANTRONICS INC. ALL RIGHTS RESERVED.
DUPLICATION PROHIBITED WITHOUT PERMISSION OF KANTRONICS.
This “sign-on” message (which is different for each product, but with this
format) appears when the TNC is first turned on and after any soft reset, in
-
cluding changing the NUMNODES, PBBS, MAXUSERS or MYREMOTE
commands, or issuing the RESET command.
Link state is:
This message is output in response to the CONNECT and DISCONNECT
commands if the state of the link does not permit the requested action. It is
prefaced by “Can’t CONNECT” or “Can’t DISCONNECT” as appropriate
and will be followed by the current link state. A CONNECT command with
no options will display the link state of the current stream.
Current link states are:
Both devices busy
Both TNCs involved in the connection are unable to accept any more data.
CONNECTED to (callsign v path)
Your TNC is currently connected to the indicated station, using the path
given.
CONNECT in progress (callsign)
Your TNC is attempting to establish a connection.
Device busy
Your TNC is unable to accept any more data from the remote station at this
time.
DISC in progress
Your TNC is attempting to disconnect from another station.
Appendix E: Additional Information Messages from the KAM’98
User’s Guide 354 KAM’98 v 8.3
To Next Page