DISCONNECTED
No connection exists on the current stream.
FRMR in progress
Your TNC has detected an error in the protocol. This is normally caused by
two TNCs using the same callsign, resulting in both of them trying to re
-
spond to the same message.
Remote device busy
The remote TNC is unable to receive any more data from the radio at this
time.
Waiting ACK and device busy
Your TNC has sent a packet to another station and is waiting for the ac-
knowledgment, but your TNC is not able to accept any data from the radio at
this time.
Waiting ACK and remote busy
Your TNC has sent a packet to another station and is waiting for the ac-
knowledgment, and the remote TNC is not able to accept any data from the
radio at this time.
Waiting ACK and both devices busy
Your TNC has sent a packet to another station and is waiting for the ac-
knowledgment, but neither your TNC nor the other station’s TNC is able to
accept any data from the radio at this time.
Waiting acknowledgment
You have sent a packet of data to another station, and your TNC is waiting
for the acknowledgment.
MESSAGES WOULD BE LOST
This message indicates that you have attempted to set the PBBS size too
small to hold all of the existing messages in the mailbox. The size is not
changed, and therefore no messages are lost. If you want to make the mail
-
box smaller, you must first delete some of the messages or set the PBBS to 0,
erasing all of the messages, then set the new PBBS size.
Messages from the KAM’98 Appendix E: Additional Information
KAM’98 v 8.3 355 User’s Guide
To Next Page