....RAM ERROR
xxxK BYTES
If this message appears when you perform a hard reset, the TNC has detected
a problem with the installed RAM, and reports how much of the RAM it
found.
***retry count exceeded
*** DISCONNECTED
The number of tries set by the RETRY command has been exceeded. There
-
fore the connection has been broken.
S00
This message from the TNC indicates that it is in the HOST mode of opera-
tion, and has just performed a reset. To exit the Host mode, you must send
three characters to the TNC from your keyboard. See the Host mode section
of the manual for details. Two FEND characters precede this message and
one FEND character follows this message, but they may not be visible (de-
pending on your terminal program).
Value out of range
If the syntax of the command is legal, but the value specified is too large or
too small for this command, the value out of range message is returned. A $
is used to point to the bad value.
was
Whenever one of the parameters is changed, the previous value is usually
displayed.
Example:
cmd:AX25 OFF
AX25L2V2 was ON
Messages from the KAM’98 Appendix E: Additional Information
KAM’98 v 8.3 357 User’s Guide
To Next Page