NATO socket
• The battery switch located inside
the left front of the gooseneck must
be opened.
Battery switch
The location of battery switch
In an emergency, the power
can be cut off by turning off
the battery switch.
• Parking lights must be turned on
from the truck cabin. In order for the
steering system to work, the right
parking electric line of the truck
must be working. (24N (ISO 1185)
Pin 6 / 15 Pin ADR (ISO 12098) Pin
6).
After the above operations are
completed, the trailer brakes
must be released for the stee-
ring system to work properly
when the trailer is unloaded
and not in motion. Operating
the steering system when the
vehicle is loaded and not in
motion may damage the
vehicle's steering system
mechanisms.
As stated on the warning label
below, do not force the vehicle
to maneuver more than 90
degrees to the right and left.
After the 90 degree maneuver,
the vehicle completes the turn
mechanically due to its struc-
ture. Any further forcing will
damage the system.
Steering Limit
3.6.2. Mechanical Alignment and
Calibration
In order for the automatic alignment
process to work correctly, the mechani-
cal alignment and sensor calibrations
must be done correctly.
To Next Page