• First, close the lid and close the
latch on the lid.
• Lock the latch to tighten the cover.
3.12. Bumper
Kaessbohrer Low-bed vehicles have one
type bumper, that is fixed bumper.
On the bumper, there are reflectors, la-
bels, spotlight, headlight assembly and
horn lamps connected to the headlight
assembly, parts necessary for ramp use
and a mat attached to the bumper.
3.12.1. Fixed Bumper
The bumper is welded to the chassis and
provides ease in the use of ramps and
the transition between ramp types, as it
has an omega shape structure.
Fixed Bumper
3.13. Wooden Floor
Hard wood flooring is used on the base.
It is fixed to the chassis by applying a
base screw to the wooden floor.
Hard wood flooring
3.14. Extendable Chassis
The maneuvers mentioned be-
low must be done on absolu-
tely flat ground with a tow
truck suitable for Low-Loader.
The trailer must be mechani-
cally aligned. Otherwise, the
pool chassis and hydraulic
equipment may be damaged.
3.14.1. Extending The Chassis
1)Raise the bottom of the pool by placing
a support under the pool.
Placing a support under the pool
2)Make electrical connections.
Electrical connections
3)Place the pool on the supports by low-
ering the vehicle from the gooseneck. In
order to lower the gooseneck, keep the
pump start button pressed and at the
same time lower the 3 lever. Lowering
the chassis too far may cause the chas-
sis to contract, causing the vehicle to not
extend. With the lever number 3, make
the chassis relax with small up and down
movements.
To Next Page