63 / 84
5.2.2. Separating the Low-Loader
from the Truck
Follow these steps to separate the low-
loader from the truck:
• Dock the truck and Low-loader in
the parking area straight and
aligned.
• Pull the parking brake and secure
the vehicle with wheel chocks
against slipping.
• Place the aluminium supports under
the Low-loader as shown in the
picture.
Placing the aluminium supports
• By adjusting the air bellows of the
truck (if the truck has this feature,
refer to the truck's user manual) or
by using the gooseneck lowering-
lifting lever control (1) located on the
Low-loader's gooseneck, ensure
that the Low-loader is seated on the
aluminium supports. (During goose-
neck lowering and lifting, the elec-
tropump power cable connection
between the tractor and the semi-
trailer must be made and the elec-
tropump power button (2) must be
pressed during the process.)
Pump start button
Hydraulic control levers
• Disconnect all electrical, hydraulic
and pneumatic connections be-
tween the truck and the Low-loader.
• Turn the 5th wheel lock system to
the “On” position.
Fifth wheel locking system
A- Locked
B- Unlocked
• Separate 500 mm from the Low-
loader by slowly moving the truck
forward. Lower the level of the
To Next Page