Closing the lock
Disengage the parking brake of the
vehicle.
3.14.2. Shortening The Chassis
1)Raise the bottom of the pool by placing
a support under the pool.
Placing the supports under the pool
2)Make the electrical connections
The location of the electrical connections
3)Place the pool on the supports by low-
ering the vehicle from the gooseneck. To
lower the gooseneck, keep the pump
start button pressed and at the same
time lower the lever 3. Lowering the
chassis too far may cause the chassis to
contract, causing the vehicle to not
shorten. Take the twitch of the chassis
by making small up and down move-
ments with the number 3 lever.
Pump start button
Hydraulic control levers
4)Engage the vehicle’s parking brake.
Red park brake
5)Remove the safety pin, unlock with the
screw lever on the gooseneck. If it is diffi-
cult to unlock, move the vehicle to the
right or left.
To Next Page