required torque values (630 ÷ 650
Nm) are reached.
8.14.3. Tire Inflation Pressure
Lastik basıncı araç birkaç saat
park halinde bekledikten son-
ra lastikler “soğukken” kon-
trol edilmelidir.
Bir lastiğin havasını asla sı-
cakken indirmeyiniz.
Takılı iki lastik arasındaki ye-
tersiz basınç anormal lastik
aşınmasına ve temas halinde-
ki kısımların aşırı ısınmasına
neden olur. Normal lastik aşın-
ması için lastik hava değerleri
düzenli olarak kontrol edilmeli
ve basınç değerleri tüm lastik-
lerde eşit olmalıdır.
8.14.4. Alloy Rim Wheels
The tightening torque specified by the
valve manufacturer must be between the
values below.
9 - 14 Nm (0.91 – 1,41 kgm)
Only in this way can the correct com-
pression of the O-ring seal be achieved.
Over-tightening the valve can deform the
O-ring and damage the valve seat, caus-
ing air leakage.
8.15. Hidrolic Oils
Hydraulic Oil Operating Temperature:
The minimum operating temperature is
-20°C and the maximum operating tem-
perature is 80° C. The ideal operating
temperature of the oil in the system is
35°C – 55°C.
• Mineral based hydraulic oil should
be used in the system.
• The quality, cleanliness and operat-
ing fluidity of hydraulic oil are very
important for its economy and serv-
ice life.
• The viscosity of the hydraulic oil in
the system should be between 12–
100 cSt (mm²/s). Ideal viscosity is
between 20–40 cSt.
• Low-viscosity hydraulic oils should
be preferred in cold weather and
high-viscosity hydraulic oils in hot
weather.
To Next Page