interfering with the steering system.
The blocking is removed when the ve-
hicle speed drops below the 15 km/h
limit.
2 Hz 2 Hz Appears when entering the Angle Sen-
sor Calibration process. Continues un-
til the vehicle's straight angle values
are saved.
Constantly working 2 Hz Appears when the flat angle values of
the vehicle are recorded in the Angle
Sensor Calibration process. Limit an-
gle values continue until saved.
Constantly working Constantly working It is seen when the limit angle values
of the vehicle are recorded in the An-
gle Sensor Calibration process. Tem-
porary recordings continue until they
are permanently saved or the Angle
Sensor Calibration process is
cancelled.
2 Hz x3 2 Hz x3 Appears when temporary records are
saved permanently in the Angle Sen-
sor Calibration process. It also indi-
cates successful completion of Angle
Sensor Calibration.
2 Hz x3 Constantly working Appears when the calibration process
is canceled at any step of the Angle
Sensor Calibration process. In this
case, if there are temporary records,
they are deleted and the Angle Sensor
Calibration process is automatically
terminated.
2 Hz
(<>)
2 Hz
(<>)
Appears when the fifth wheel angle
value or the steering hub angle value
falls outside the limit values recorded
in the Angle Sensor Calibration. This
indicates that the Angle Sensor Cali-
bration was performed incorrectly.
To Next Page