Keba KeContact Series - Page 98

Load management program
98 / 156
State:
Shows the state of the current Charging Session.
Display values:
 Not plugged in:
No electric vehicle is connected to the Wallbox.
 Standby:
The vehicle is connected, but on standby.
 Charging:
The vehicle is charging or in a charging pause and the vehicle is not
blocked.
 Blocked:
The vehicle has been blocked by the Wallbox or no active charging
transaction exists.
 Error:
The socket is degraded or fatal.
Authorization?
Indicates whether the Charging session is authorized.
Display values:
 Yes/No
Authorization Type:
Type of the identification of the holder of the Charging Token.
Display values:
 PEV-ID:
The token holder is identified by a PEV-ID.
 RFID:
The token holder is identified by a RFID.
 Manual:
The session has been authorized via the Graphical User Interface.
 Host:
A Charging session has been authorized by the host using a Remote
Start Transaction message (OCPP) or equivalent.
Authorization token:
ID of the charging token (either PEV-ID or Token RFID or Session Se-
quence ID). Session Sequence ID will be used for manually generated
charging tokens.
Authorization:
Approval reason:
The reason entered via a free text field when manually approving a
Charging Session.
- The “Approval reason” will be ignored unless the [Authorize] button is
pressed and is stored just for information purposes.
Buttons:
View details:
Press the [View details] button to show the “Charging session details”
screen.
Unblock:
Press the button [Unblock] button to unblock a blocked session, the Elec-
tric Vehicle may resume charging.
Block:
Press the [Block] to switch a session into the (internal) session state
“blocked”. The Electric Vehicle stops charging.
Authorize:
If the session has not yet been authorized and the button [Authorize] is
pressed, then the Electric Vehicle is authorized to start charging.
- "Authorize" is only possible if the session is in state "Waiting for Authori-
zation".