KEM TRICOR TCE80 -E Series - Control Mode; Function of the Keys; Submenus in the Main Menu

Manual Operation
48
4.5 Control Mode
In the control mode the TCE8000 can be adapted to the individual application. As unintentional changes of the
settings might cause problems, some submenus are password protected.
To enter the control mode proceed as follows:
Press “P” for about 3 seconds
The display shows:
MAIN MENU
ZERO OFFSET
UP DOWN EXIT
With the keys “UP” and “DOWN” you can scroll through the main list.
Select the desired submenu and confirm with “P”.
4.5.1 Function of the keys
In the setup menu some pushbuttons have changing functions, indicated in the display above the pushbutton:
P Confirms the selection in a list or any kind of inputs
Reset Performs the indicated function
Display Performs the indicated function.
Info Performs the indicated function.
In most cases exits the current menu point without altering the original value
4.5.2 Submenus in the Main Menu
In the Main Menu the following submenus are addressable:
ZERO OFFSET:
Performing the automatic offset procedure.
This submenu is password protected.
DISPLAY:
Presetting the display.
Changes made in this submenu have no influence on the general function as well on the accuracy of the unit.
SETUP:
Adjusting the TCE8000 and configuring the inputs and outputs.
This submenu is password protected.
I/O-TEST:
Setting the outputs to defined values and displaying the actual status of the control inputs for testing the electrical
connections.
This submenu is password protected.
SERVICE:
Calibrating TCE8000.
This submenu is password protected.