Manual Operation
66
4.5.8.2 RECALL DATA menu
In the submenu “RECALL DATA” the old settings are reloaded from the backup memory.
Reloading the old settings is recommended if after bigger changes in the setup the unit does not work properly
any more.
NOTE:
Backup data overwritten with “SAVE DATA” cannot be restored!
DATA CONFIG MENU
RECALL DATA
UP DOWN EXIT
P
RECALL BACKUP DATA?
START EXIT
Start the recall process with “START” or skip with “EXIT”.
If “START” is pressed, the display shows for some seconds
MEMORY
ACCESS
After that for about 2 seconds
READY
The display returns to the DATA CONFIG menu.
4.5.9 SETUP RESET TOTAL menu
In the submenu SETUP / RESET TOTAL the total counter can be reset to zero
SETUP MENU
RESET TOTAL
UP DOWN EXIT
P
WARNING
ALL TOTAL VALUES
WILL BE RESET!!
START EXIT
Reset the total with “START” or skip with “EXIT”.
The display returns to the RESET TOTAL menu.
To Next Page
Loading...
Need help?
General
