Manual Operation
49
4.5.3 ZERO OFFSET Menu
Select in the main menu
MAIN MENU
ZERO OFFSET
UP DOWN EXIT
Press “P”. The display shows
ENTER CODE
2206
LEFT UP EXIT
Change the indicated number with “LEFT” and “UP” to 2207 and confirm with “P”.
If a wrong code is entered, the display shows “ERROR” for about 2s and then asks for a new input.
When the correct code is entered the display shows:
START OFFSET
PROCEDURE
SLOW FAST EXIT
Press “SLOW” or “FAST”. The display shows
MAKE ZERO 10µs
OLD ZERO: 0.000µs
NEW ZERO: µs
The time counter counts down to zero. The display shows:
* END OF ZERO-POINT *
OLD ZERO: 0.000µs
NEW ZERO: 0.123µs
EXIT
Press “EXIT” to return to the measuring mode.
To Next Page
Loading...
Need help?
General
