X5 FastMig
Operating manual - EN
4.1 Daily maintenance
Disconnect the power source from the mains before handling electrical cables.
Maintenance of power source and wire feeder
Follow these maintenance procedures to maintain the proper functioning of the welding system:
• Check that all covers and components are intact.
• Check all the cables and connectors. Do not use them if they are damaged and contact service for replacements.
• Check the wire feeder's feed rolls and the pressure handle. Clean and lubricate with a small quantity of light
machine oil if needed.
For repairs, contact Kemppi at www.kemppi.com or your dealer.
Welding gun maintenance
For Flexlite GX MIGgun instructions, refer to userdoc.kemppi.com.
© Kemppi
102
1920960 / 2144
To Next Page
Loading...
Need help?
General
