X5 FastMig
Operating manual - EN
Factory reset
Reset/Cancel
Default = Cancel
Safe wire inch
(with MIG only)
OFF/ON When ON, and the arc doesn't ignite, the
filler wire is fed 5 cm When OFF, 5 m of
filler wire is fed.
Cable calibration
(with MIG only)
Start/Cancel The date and time and the calibration
information of the previous calibration is
also shown.
Refer to "Calibrating welding cable" on
page73 for cable calibration.
VRD
(with MMA and gouging only)
OFF/12V/24V
Default = OFF
Voltage reduction device (VRD) reduces
the open-circuit voltage to maintain
below a certain voltage value.
3.3.8 Auto control panel: Applying welding programs
Use the welding program that is in accordance with your welding setup (e.g. welding wire and gas properties).
The use of additional welding programs and Wise features is possible with the X5 FastMig Synergic equipment in
MIG operation mode.
1. Go to the Memory channels view. (Refer to "Auto control panel: Memory channels" on page82 for more inform-
ation.)
2. Enter the actions menu.
3. Select Create channel.
>> A filter view opens.
4. MIG only: Use the filter options (e.g. material, wire material or wire diameter) to find the welding programs best
suited for the purpose.
The operation mode set in the panel Settings determines for which main welding process the programs here are
shown. In MIG mode, the Process selection in the Create channel view allows to narrow down the search more spe-
cifically to different MIG processes.
© Kemppi
92
1920960 / 2144
To Next Page
Loading...
Need help?
General
