X5 FastMig
Operating manual - EN
5. MIG only:Once ready, go to the Welding program selection at the bottom to view the suitable welding programs.
6. MIG only:Select a welding program.
>> The selected welding program is now shown in the filter view.
7. To save, scroll down to Save to and select it.
8. Select the memory channel slot for saving and confirm.
Once ready, you can continue to the Welding parameters view to adjust the welding settings for the new channel, create
a new channel or go back to the Channels view.
Tip: It is also possible to create new channels based on all of the unused welding programs available for the
selected operation mode by selecting Create allin the Channel view's actions menu. This option uses the avail-
able memory channel slots.
© Kemppi
93
1920960 / 2144
To Next Page
Loading...
