X8 MIG WELDER 2.5 Operation
Figure 18: The Settings view menu in the Advanced mode
For more information on welding programs, see Welding programs in Control Pad on page 102.
DPulse menu
With the DPulse process in a welding program, Settings features an additional menu, DPulse. For
more information, see Standard MIG welding processes in MIG X8 Welder on page 138.
Wise feature menu
Wise feature displays the Wise features available for use with the welding program.
For more information, see Wise features on page 146.
Trigger logic menu
Trigger logic displays the trigger logic options: 2T, 4T and WP Switch.
For more information, see Trigger logic functions on page 152.
Start and stop logic menu
Start and stop logic displays several options. For more information, see Start and stop functions
on page 153.
Parameters
The parameters available vary according to the welding process used:
• Wire feed speed
In addition to wire feed speed, you can adjust the minimum and maximum values of wire feed
speed here.
OPERATING MANUAL | EN 101
©
KEMPPI 2017 | 1817
To Next Page
Loading...
Need help?
General
