X8 MIG WELDER 2.5 Operation
When using WiseRoot+, depending on the welding program, you can adjust the following
parameters through Settings > Parameters:
• Wire Feed Speed
• min: adjusts the minimum set value for wire feed speed
• max: adjusts the maximum set value for wire feed speed
• Fine tuning: adjusts the heat of the arc.
• Dynamics: -10...+10. Adjusts the short circuit behavior. On the minus side, the arc is softer. On
the plus side, the arc is harder.
• StartPower: -30...+30. Adjusts the power level for arc ignition.
• StartLevel: -30...+30. Fine tunes the arc length for arc ignition.
• StopPower: -30...+30. Adjusts the power level for arc stop.
Using WiseThin+
WiseThin+ is a synergic MIG/MAG process whose short-arc features are optimal for welding sheet
metals (plate thickness 0.8 - 3.0 mm). It is based on precise measurement of voltage between the
welding gun nozzle and the workpiece. The measurement data serves as input for the voltage
control. The process reduces heat input, deformation and spatter. WiseThin+ is also optimal for
position welding with thicker plates.
To adjust welding power / wire feed speed, in the Control Pad's Welding view, turn the left knob.
To fine tune the voltage while welding, in the Control Pad's Welding view, turn the right knob.
Figure 34: WiseThin+ Welding view
When using WiseThin+, depending on the welding program, you can adjust the following
welding parameters through Settings > Parameters:
• Wire feed speed
• min: adjusts the minimum set value for wire feed speed
• max: adjusts the maximum set value for wire feed speed
• Fine tuning: adjusts the voltage (arc length).
OPERATING MANUAL | EN 145
©
KEMPPI 2017 | 1817
To Next Page
Loading...
