X8 MIG WELDER 2.4 Installation
2.
Push in the new neck and turn the neck tightener half a turn clockwise to secure it. Make sure
you push the neck deep enough: When the neck is correctly inserted, the groove on the neck
is completely hidden under the neck tightener.
Note:
You can rotate the neck into different positions without loosening the neck tightener.
Changing gas nozzle (gas-cooled gun)
Screw the gas nozzle into its place.
OPERATING MANUAL | EN 79
©
KEMPPI 2017 | 1817
To Next Page
Loading...
