FETCh3:POWer? <scale>, [<record #>, [<first_pt>, [<last_pt>,]]] (@<volt_ch>), (@<curr_ch>)
Performs post-processing calculation on the specified range of readings and returns power on the specified record
for a paired/ coupled channel.
This command is only allowed on the channels with power analysis mode enabled.
ACQuire3:POWer:ANALysis:STATe ON
This SCPI is supported on the DAQM909A Digitizer module only.
Parameter Typical return
<scale> = The gain of the current channel <curr_ch>
<record #> = An integer indicating the specified data record for a channel.
Default: 1
<first_pt> = An integer indicating the first data point of the range of readings to perform
power analysis.
Default: 1
<last_pt> = An integer indicating the last data point of the range of readings to perform
power analysis.
Default: 256
<volt_ch> = Voltage channel number
<curr_ch> = Current channel number
(none)
Returning the power of the range of readings from data number 2 to 500 in the first record of Voltage channel 201 and Current channel 202.
FETCh3:POWer? 1,1,2,500,(@201),(@202)
Typical response: +9.73982085E-03, +1.98526811E-02,+2.33925991E-02,.........,+2.93494016E-02
Keysight DAQ970A/DAQ973A Programming Guide 133
2 SCPI Programming
To Next Page
Loading...
Need help?
General
