Keysight Technologies DAQ970A - Calculate:limit Subsystem; Calculate:limit:lower; Calculate:limit:upper; Calculate:limit:lower:state

CALCulate:LIMit Subsystem
This subsystem specifies measurements and indicates when a reading limit has been exceeded.
Only supported on multiplexer modules (DAQM900A, DAQM901A, DAQM902A, and DAQM908A) and
DAQM907A multifunction module.
Command Summary
CALCulate:LIMit:LOWer
CALCulate:LIMit:UPPer
CALCulate:LIMit:LOWer:STATe
CALCulate:LIMit:UPPer:STATe
66
Keysight DAQ970A/DAQ973A Programming Guide
2 SCPI Programming