MMEMory Subsystem
MMEMory (mass memory) subsystem can be divided into three categories, as below:
Data Transfer Commands
These commands transfer files into and out of the instrument's mass memory.
Command Summary
MMEMory:DOWNload:DATA
MMEMory:DOWNload:FNAMe
MMEMory:FORMat:READing:CHEAder
MMEMory:FORMat:READing:CSEParator
MMEMory:FORMat:READing:RLIMit
MMEMory:FORMat:READing:RLIMit:COUNt
MMEMory:STORe:DATA
MMEMory:STORe:DATA:AUTO
MMEMory:STORe:DATA:AUTO:FNAMe
MMEMory:UPLoad?
STATe and PREFerence Management Commands
These MMEMory subsystem commands save and load instrument states (state files) and preferred settings for non-
volatile parameters (preference files). In general, state files store volatile settings associated with measurements.
Preferences are non-volatile parameters associated with the instrument, but not any specific measurement. The fol-
lowing table summarizes what information is in each file.
Command Summary
MMEMory:LOAD:PREFerences
MMEMory:STORe:PREFerences
MMEMory:LOAD:STATe
MMEMory:STORe:STATe
MMEMory:STATe:RECall:AUTO
MMEMory:STATe:RECall:SELect
MMEMory:STATe:VALid?
178
Keysight DAQ970A/DAQ973A Programming Guide
2 SCPI Programming
To Next Page
Loading...
Need help?
General
