Error code Error message
751 Autocalibration memory write failure
752 Autocalibration memory read failure
753 Autocalibration measurement out of range
754 Module autocalibration needed due to mainframe change
760 Operation aborted; high voltage present on input terminals
Miscellaneous Errors (+800...)
Error code Error message
800 Nonvolatile memory write failure
810 State has not been recalled
820 Model and serial numbers not restored
821 Controller and measurement board model numbers do not match
822 Controller and measurement board serial numbers do not match
823 Incorrect firmware loaded for this model number
Keysight DAQ970A/DAQ973A Programming Guide 365
3SCPI Error Messages
To Next Page
Loading...
Need help?
General
