Keysight Technologies DAQ970A - Page 364

Error code Error message
713 Calibration error; ADC calibration failed; fine offset for setup 'ACI'
713 Calibration error; ADC calibration failed; fine offset for setup 'ACV'
713 Calibration error; ADC calibration failed; fine offset for setup 'DCV'
713 Calibration error; ADC calibration failed; fineDcCancel found non-monotonic value in setup 'ACI'
713 Calibration error; ADC calibration failed; fineDcCancel found non-monotonic value in setup 'ACV'
713 Calibration error; ADC calibration failed; fineDcCancel found non-monotonic value in setup 'DCV'
713 Calibration error; DCV 10M input impedance gain adjustment out of range
715 Calibration error; must perform +100mV DCV calibration before -100mV
715 Calibration error; must perform +100uA DCI calibration before -100uA
715 Calibration error; must perform +10V DCV calibration before -10V
715 Calibration error; must perform 10MOhm calibration before 100MOhm
720 Calibration error; DCV offset out of range
721 Calibration error; DCI offset out of range
722 Calibration error; RES offset out of range
723 Calibration error; FRES offset out of range
724 Calibration error; extended resistance self cal failed
725 Calibration error; 1000V DC correction out of range
726 Calibration error; ACV offset out of range
727 Calibration error; ACI offset out of range
730 Calibration error; precharge DAC convergence failed
731 Calibration error; A/D turnover correction out of range
732 Calibration error; AC flatness calibration failed
733 Calibration error; AC low frequency correction out of range
734 Calibration error; AC flatness calibration restarted by function/range change
735 Calibration error; 1 kHz AC flatness frequency point must be last frequency point in sequence
736 Calibration error; DCI 100uA range self-cal failed
740 Calibration data lost: secure state
740 Calibration information lost; count, security state, security code, string
741 Calibration data lost: string data
742 Calibration data lost: corrections
746 System information write failure
747 System information read failure
748 Calibration memory write failure
749 Calibration memory read failure
750 Autocalibration corrections lost lost; due to firmware revision change
750 Autocalibration corrections lost
364
Keysight DAQ970A/DAQ973A Programming Guide
3SCPI Error Messages