Factory Reset State
Tables below show the states of the instrument from the front panel (press [Save Recall] > Set to Defaults > Factory
Reset), or from the remote interface (*RST command).
Measurement configuration Factory reset state
Function DC Volts
Range Autorange (for all functions)
Integration Time 1 PLC
NPLC On, 1 power line cycles (PLC)
Auto zero On
Input Resistance 10 MΩ (fixed for all DCV ranges)
Channel Delay Automatic Delay
Totalizer Reset Mode Count Not Reset When Read
Totalizer Edge Detect Rising Edge
Scanning operations Factory reset state
Scan List Empty
Reading Memory All Readings are Cleared
Min, Max, and Average Not Changed
Scan Trigger Source Immediate
Scan Interval 10 Seconds
Scan Count 1
Scan Reading Format Reading Only (No Units, Channel, Time)
Monitor in Progress Stopped
Measurement scaling Factory reset state
Gain Factor ("M") 1
Offset Factor ("B") 0
Scale Label VDC
Alarm limits Factory reset state
Alarm Queue Not Cleared
Alarm State Off
HI and LO Alarm Limits 0
Alarm Output Alarm 1
Alarm Output Configuration Latched Mode
22
Keysight DAQ970A/DAQ973A Programming Guide
1 Remote Operation
To Next Page
Loading...
Need help?
General
