Keysight Technologies DAQ970A User Manual

Instrument Preset State
Table below shows the states of the instrument from the front panel (press [Save Recall] > Set to Defaults > Preset
State), or from the remote interface (SYSTem:PRESet command).
Measurement configuration Instrument preset state
Function No Change
Range No Change
Advanced Settings No Change
Totalizer Reset Mode Count Not Reset When Read
Totalizer Edge Detect Rising Edge
Scanning operations Instrument preset state
Scan List No Change
Reading Memory All Readings are Cleared
Min, Max, and Average No Change
Scan Interval Source No Change
Scan Interval No Change
Scan Count No Change
Scan Reading Format No Change
Monitor in Progress Stopped
mX+b scaling Instrument preset state
Gain Factor ("M") No Change
Offset Factor ("B") No Change
Scale Label No Change
Alarm limits Instrument preset state
Alarm Queue No Change
Alarm State No Change
HI and LO Alarm Limits No Change
Alarm Output Configuration No Change
Alarm Output State Output Lines are Cleared
Alarm Output Slope No Change
24
Keysight DAQ970A/DAQ973A Programming Guide
1 Remote Operation

Keysight Technologies DAQ970A Specifications

General

Brand	Keysight Technologies
Model	DAQ970A
Category	Multiplexer
Language	English