Error code Error message
401 Temperature warning: unit overheating
402 Temperature error: unit overheated; DMM power turned off to prevent damage
403 Power error: DMM power lost
404 Real Time Clock battery is low, settings may be lost
514 Not allowed
514 Not allowed; Instrument locked by another I/O session
521 Communications: input buffer overflow
522 Communications: output buffer overflow
532 Not able to achieve requested resolution
540 Cannot use overload as math reference or offset
541 Cannot use zero as math reference for PCT scaling function
542 Measured dB reference too small
550 Not able to execute command in local mode
Self-test Errors (+600...)
Error code Error message
611 Self-test failed; Real Time Clock reset, check battery
612 Self-test failed; not able to communicate with keyboard processor
613 Self-test failed; not able to communicate with power processor
614 Self-test failed; not able to sense line frequency
615 Self-test failed; not able to communicate with DMM
616 Self-test failed; DMM calibration memory reading error
617 Self-test failed; DMM FPGA unconfigured
618 Self-test failed; DMM FPGA bus error
619 Self-test failed; DMM FPGA clock
620 Self-test failed; DMM shift register
621 Self-test failed; DMM overload sense stuck on
622 Self-test failed; DMM ADC generic error
623 Self-test failed; DMM ADC integrator saturated
624 Self-test failed; DMM Coarse ADC error
625 Self-test failed; DMM ADC offset
626 Self-test failed; DMM ADC noise
627 Self-test failed; DMM Fine ADC generic error
628 Self-test failed; DMM Fine ADC off-scale low
629 Self-test failed; DMM Fine ADC off-scale high
630 Self-test failed; DMM Fine ADC range
358
Keysight DAQ970A/DAQ973A Programming Guide
3SCPI Error Messages
To Next Page
Loading...
Need help?
General
