INITiate3 (@<ch_list)
Initiates module digitizing and clears the previously set of reading records from reading memory on the specified
channels. Reading records for other channels will remain in the reading memory.
Only supported on DAQM909A Digitizer module.
Parameter Typical return
(none) (none)
Use the INITiate3 command after configuring the Digitizer channels to initiate the digitizing operation.
ACQ3:VOLT DEF,DEF,DEF,DEF,DEF,DEF,(@201)
INIT3 (@201)
156
Keysight DAQ970A/DAQ973A Programming Guide
2 SCPI Programming
To Next Page
Loading...
