SENSe3:FILTer:MODE {TIME | FREQuency}, (@<ch_list>)
SENSe3:FILTer:MODE? (@<ch_list>)
Sets the module ADC filter mode to either TIME or FREQuency on the specified channels.
This SCPI is supported on the DAQM909A Digitizer module only.
Parameter Typical return
{TIME | FREQuency }
Default:TIME
TIME, or FREQ
Sets the ADC filter mode as FREQuency on Digitizer channel 201
SENS3:FILT:MODE FREQ,(@201)
– When TIME is selected, the module ADC is configured to use a Sinc5 filter. When FREQuency is selected, the
module ADC is configured to use a wideband filter.
– The allowed maximum sample rate on channels with FREQuency filter mode is 100 kSa/s. For sample rate
200kSa/s and above, all the channels in the entire module are required to be in TIME filter mode.
SENSe3:FUNCtion[:ON] "<function>", (@<ch_list>)
SENSe3:FUNCtion[:ON]? (@<ch_list>)
Sets the measurement function on the specified channels.
This SCPI is supported on the DAQM909A Digitizer module only.
Parameter Typical return
STRain:QUARter
STRain:HALF:BENDing
STRain:HALF:POISson
STRain:FULL:BENDing
STRain:FULL:BENDing:POISson
STRain:FULL:POISson
VOLTage[:DC]
Default: VOLTage[:DC]
The short form of the selected function is returned in quotation marks, with no optional keywords:
"STR:DIR", "VOLT", and so on.
Selects the DC voltage function on Digitizer channel 201:
SENS3:FUNC "VOLT:DC",(@201)
284
Keysight DAQ970A/DAQ973A Programming Guide
2 SCPI Programming
To Next Page
Loading...
