CONFigure:STRain:{FULL|HALF}:BENDing [{<gage_factor> | MIN | MAX | DEF}, [{<range> | MIN |
MAX | DEF}, [{<resolution> | MIN | MAX | DEF},]]]] (@<ch_list>)
Only supported on DAQM900A, DAQM901A, DAQM902A, and DAQM908A multiplexer modules.
Configures the channels for full and half bending bridge strain gage measurements, but they do not initiate the
scan. This command redefines the scan list.
The CONFigure command does not place the instrument in the "wait-for-trigger" state. Use the INITiate or READ?
command in conjunction with CONFigure to place the instrument in the "wait-for-trigger" state.
Parameter Typical return
<gage_factor> = Any numeric value between 0.5 and 5
Default = 2
<range> = {Auto | 100 mV | 1V | 10 V | 100V | 300V}
Default = AUTO
<resolution> = 1 PLC (0.000003 x Range)
None
Configures a full bending bridge strain gage measurement on channel 101:
CONF:STR:FULL:BEND (@101)
Keysight DAQ970A/DAQ973A Programming Guide 99
2 SCPI Programming
To Next Page
Loading...
