Keysight Technologies E5260 Series

4- 70 Keysight E5260/E5270 Programming Guide, Edition 4
Command Reference
Command Reference
51 : Returns the binary search measurement settings:
BSM mode,past;BST hold,delay;BSVM mode
[;BGI chnum,mode,condition,Irange,Itarget] or
[;BGV
chnum,mode,condition,Vrange,Vtarget]
[;BSV chnum,range,start,stop[,Icomp]] or
[;BSI
chnum,range,start,stop[,Vcomp]]
[;BSSV
chnum,polarity,offset[,Icomp]] or
[;BSSI
chnum,polarity,offset[,Vcomp]]
<CR/LF^EOI>
52 : Not used.
53 : Returns the SMU series resistor ON/OFF status:
SSR chnum,mode
[;SSR chnum,mode]
:
[;SSR chnum,mode]<CR/LF^EOI>
54 : Returns the auto ranging mode status:
RM chnum,mode[,rate]
[;RM chnum,mode[,rate]]
:
[;RM chnum,mode[,rate]]<CR/LF^EOI>
55 : Available only for the Keysight E5270B. Returns the A/D converter
settings:
AAD chnum,type
[;AAD chnum,type]
:
[;AAD chnum,type]<CR/LF^EOI>
56 : Available only for the Keysight E5270B. Returns the ADC averaging
or integration time setting:
AIT0,mode,time;AIT1,mode,time;
AZ mode<CR/LF^EOI>
57 : Returns the source/measurement wait time settings:
WAT0,set_set;WAT1,set_meas<CR/LF^EOI>