Keysight E5260/E5270 Programming Guide, Edition 4 4- 81
Command Reference
Command Reference
LSVM
The LSVM command selects the data output mode for the linear search
measurement.
Syntax LSVM mode
Parameters mode : Data output mode. Integer expression. 0 (initial setting) or 1.
0 : Returns Data_search only.
1 : Returns Data_search and Data_sense.
where
Data_search is the value forced by the search output channel set by the
LSV or LSI command.
Data_sense is the value measured by the search monitor channel set by
the LGI or LGV command.
For data output format, refer to “Data Output Format” on page 1-22.
Example
Statements
OUTPUT @E5270;"LSVM 1"
MCH
The MCH command selects the measurement channel for the data is displayed on
the front panel LCD.
Syntax MCH chnum
Parameters chnum : Measurement channel number. The value must be slot number where
the module has been installed. Integer expression. 1 to 8 (1 and 5 are
not available for HPSMU). See
Table 4-1 on page 4-9.
Example
Statements
OUTPUT @E5270;"MCH 1"
To Next Page
Loading...
