Keysight Technologies E5260 Series Programming Guide

4- 118 Keysight E5260/E5270 Programming Guide, Edition 4
Command Reference
Command Reference
TGSO
The TGSO command selects the edge trigger or the gate trigger for the Step Output
Setup Completion trigger output set by the TGP
port,2,polarity,2 command. See
Figure 4-2 on page 4-113
This command is available for the staircase sweep, pulsed spot, pulsed sweep,
staircase sweep with pulsed bias, and multi channel sweep measurements.
Syntax TGSO mode
Parameters mode : Edge trigger or gate trigger. Integer expression.
1: Edge trigger (initial setting).
2: Gate trigger.
Example
Statements
OUTPUT @E5270;"TGSO 2"
See Also “TGP” and “TGPC”
TGXO
The TGXO command selects the edge trigger or the gate trigger for the
Measurement Completion trigger output set by the TGP
port,2,polarity,1
command. See
Figure 4-2 on page 4-113
Syntax TGXO mode
Parameters mode : Edge trigger or gate trigger. Integer expression.
1: Edge trigger (initial setting).
2: Gate trigger.
Example
Statements
OUTPUT @E5270;"TGXO 2"
See Also “TGP” and “TGPC”

Keysight Technologies E5260 Series Specifications

General

Brand	Keysight Technologies
Model	E5260 Series
Category	Measuring Instruments
Language	English