20 Getting Started Guide
Introduction
Instrument Information and Maintenance
This instrument has an auto-ranging line voltage input. Ensure the supply
voltage is within the specified range and the rating for the service breaker is
correct.
When installing the product in a cabinet the convection into and out of the
product must not be restricted. The ambient temperature (outside the cabinet)
must be less than the maximum operating temperature of the product by 4
° C
for every 100 watts dissipated in the cabinet. If the total power dissipated in
the cabinet is greater than 800 watts, then forced convection must be used. It
is your responsibility to ensure the ambient temperature does not exceed the
rated ambient temperature stated in the specification.
The Mains wiring and connectors shall be compatible with the connector used
in the premise electrical system. Failure, to ensure adequate earth grounding
by not using the correct components may cause product damage, and serious
injury.
Use the Keysight supplied power cord or one with the same or better electrical
rating.
To Next Page
Loading...
