Getting Started Guide 19
Introduction
Instrument Information and Maintenance
Instrument Information and Maintenance
Size and Weight
The weight and dimensions of the E7515B are as follows:
— Weight: 42.2 kg (with 2 cells)
— Height: 309 mm (323 mm with feet)
— Width: 436 mm (452.5 with lateral handles)
— Depth 554 mm
Power Requirements
Voltage & frequency: 100-240V~, 50-60 Hz, nominal
Power consumption: 1400 W Max
Electrical Safety
Mains supply voltage fluctuates up to +/- 10% of the nominal voltage.
Transient over-voltages are typically present on the mains supply.
This is a Safety Class 1 Product (provided with a protective earth ground
incorporated in the power cord). The mains plug shall only be inserted in a
socket outlet provided with a protective earth contact. Any interruption of the
protective conductor inside or outside of the instrument is likely to make the
instrument dangerous. Intentional interruption is prohibited (IEC 61010-1).
If this product is not used as specified, the protection provided by the equipment
could be impaired. This product must be used in a normal condition (in which all
means for protection are intact) only. Install the instrument so that the
detachable power cord is readily identifiable and easily reached by the operator.
The detachable power cord is the instrument disconnecting device. It
disconnects the mains circuits from the mains supply before other parts of the
instrument. The front panel switch is only a standby switch and is not a LINE
switch. Alternatively, an externally installed switch or circuit breaker (which is
readily identifiable and is easily reached by the operator) may be used as a
disconnecting device.
To Next Page
Loading...
Need help?
General
