Keysight U1252B - Setting Data Hold;Refresh Hold Mode; Figure 4-1 Data Hold;Refresh Hold Setup

4 Changing the Default Setting
106 Keysight U1251B and U1252B User’s and Service Guide
Setting Data Hold/Refresh Hold Mode
1 Set OFF to enable the Data Hold mode (manual trigger by key or bus via the
remote control).
2 Set the variation count within the 1001000 range to enable the Refresh Hold
mode (auto trigger). When the variation of the measuring value exceeds the
setting of the variation count, the Refresh Hold will be ready to trigger.
Figure 4-1 Data hold/Refresh hold setup
Press
Press
Press
Press
Press