Keysight U1252B - Figure 1-3 Tilt-Stand at Hanging Position

Getting Started 1
Keysight U1251B and U1252B User’s and Service Guide 27
To adjust the meter to a hanging position follow the steps shown in Figure 1-3
below.
Figure 1-3 Tilt-stand at hanging position
3. Flip the tilt-stand over until this side
4. Re-attach the tilt-stand to an
upright position
1. Extend the tilt-stand until its
maximum reach
2. Detach the tilt-stand
of the stand is facing the multimeter as
opposed to facing you