1 Getting Started
24 Keysight U1251B and U1252B User’s and Service Guide
Installing the battery
Your multimeter is powered by one 9 V battery. When you receive your
multimeter, the batteries are not installed.
NOTE
A new rechargeable battery comes in a discharged condition and must be
charged before use. Upon initial use (or after a prolonged storage period), the
battery may require three to four charge/discharge cycles before achieving
maximum capacity. Refer to “Charging the battery” on page 131.
CAUTION
Before you proceed with the battery installation, remove all cable
connections to the terminals and ensure that the rotary switch is at the OFF
position. Use only the batteries provided with your multimeter.
To Next Page
Loading...
