Keysight U1252B - Setting Data Logging Mode; Figure 4-2 Data Logging Setup

Changing the Default Setting 4
Keysight U1251B and U1252B User’s and Service Guide 107
Setting Data Logging Mode
1 Set to “Hand” to enable the manual data logging mode.
2 Set the interval within 0001—9999 seconds to enable interval (automatic) data
logging mode.
3 Press and hold or for more than 1 second to switch between manual
and interval data logging setup.
Figure 4-2 Data logging setup
Press
Press
Press
Press to
set interval
Press
or
Press
> 1 second