3 Instrument Operating System
Disk Drive Recovery Process
Step Notes
When you see the message Programming FPGAs...Do NOT turn off
power to the instrument, be sure to do as it says and DO NOT turn
off the instrument power at this time for ANY reason. If this process
is interrupted the instrument most likely will need to be sent back
to an Keysight Service Center for servicing before it will be usable
again.
The installation process can take up to 45 minutes. Do not turn the
instrument power off or serious damage may occur. If any pop up
windows appear, click OK or Ignore to proceed.
8. When the installation has finished, select Yes, I
want to restart my computer now, Finish.
9. After the instrument restarts, the newly
installed version of the X-Series instrument
software will run.
It is possible a newer version of the instrument software is available on the web at
http://www.keysight.com/find/xseries_software.
Additional recovery steps may be required to fully recover the system to a more current
working state. This could involve restoring your own backups of the instrument
configuration, including re-installing applications, data, and performing system
customizations.
Getting Started and Troubleshooting Guide 55
To Next Page
Loading...
Need help?
General
