Keysight x-series Getting Started And Troubleshooting

3 Instrument Operating System
Customer Installation of Software
Customer Installation of Software
3rd Party Software verified by Keysight
Keysight has verified that the following programs are compatible with the
instrument's applications:
– MathWorks MATLAB
Installation of other 3rd Party Software
The X-Series Signal Analyzer platform is an Open Windows environment, so you can
install software on the instrument. However, installation of non-approved software
may affect instrument performance. Keysight does not warrant the performance of
the analyzers with non-approved software installed.
Before installing any additional programs on the instrument, you should exit the Signal
Analyzer application.
Also, you must not remove any applications or programs that were installed on the
instrument when it was shipped from the factory.
If you install programs other than those that Keysight has tested, it could cause
problems with the instrument's applications. If this happens, you should try
uninstalling the program that has caused the problem, or try changing the program's
configuration. If this does not correct the problem, you may have to use the
Instrument Recovery system to reinstall the instrument's system software.
34 Getting Started and Troubleshooting Guide

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)